Removal

1. Remove expansion tank cap. Drain coolant at drain plugs on bottom of cylinder heads.
2. Remove drive belt(s). Disconnect all hoses to water pump and thermostat housings.
3. Remove water pump and thermostat housing as an assembly.

Installation

1. Clean all sealing surfaces and replace gaskets. Install water pump and thermostat housing assembly. Tighten bolts and nuts. See TORQUE SPECIFICATIONS at bottom of page. Attach hoses and tighten clamps.
2. Install drive belt. Apply thumb pressure to belt, and adjust belt deflection to 3/8-9/16" (10-15 mm). Fill and bleed cooling system.

1.9 Liter Water Pump Assembly	2.1 Liter Water Pump Assembly