Mirror Glass Removal & Installation

Push mirror glass at outer edge until locking lever is accessible. Push locking lever counterclockwise to unlock mirror assembly. Tilt and remove mirror glass. Disconnect electric heater element. To install, reverse removal procedure. Ensure dust boot is properly seated and locking pins are engaged in lock ring.

Power Mirror Assembly Removal & Installation

1) Disconnect battery ground strap. Pry out and disconnect electric mirror switch from door trim panel. See Fig. 8. Remove door trim panel, and carefully pull back plastic moisture barrier. Cut tie wraps securing wiring harness to door. See Fig. 9. Open harness far enough to expose and label individual wires. Remove labeled wires from plug connector.

2) Pry off plastic cap at base of mirror bracket, and remove 3 bracket securing screws. See Fig. 10. Remove mirror assembly with wiring harness. To install, reverse removal procedure, ensuring seal is positioned for proper fit and wire harness is secured to door frame with tie wraps. See Fig. 11. Check mirror for proper function.