*For reference only, your vehicle may be different.
|
1.
|
Set heater controls to maximum heating position. |
|
2.
|
Open control valve for auxiliary heater under rear seat. |
|
3.
|
Remove radiator grille. |
|
4.
|
Raise vehicle approx. 15 3/4" (40cm) at front under the cross-member with floor jack and wooden support. |
|
5.
|
Open bleeder valve on radiator. |
|
6.
|
Open bleeder valve in engine compartment. |
|
7.
|
Fill cooling system via expansion tank until tank is filled to the brim and remains full. |
|
8.
|
Run engine @2000 rpm, top up tank until coolant flows at radiator breather valve with NO air bubbles. |
|
9.
|
Add coolant until tank is full and close tank with cap. |
|
10.
|
Turn off ignition & restart engine after about 20 seconds. |
|
11.
|
At about 2000 rpm oen cap of expansion tank. |
|
12.
|
Close radiator bleeder valve when coolant flows out. |
|
13.
|
Add coolant until tank is full and close tank with cap. |
|
14.
|
Close bleeder valve in engine compartment. |
|
15.
|
Turn off engine. |
|
16.
|
Check coolant level in expansion tank and top up. |
|
17.
|
Close expansion tank with cap. |
 |
|