Manual Bleeding Procedure

1. Exhaust vacuum from power unit by depressing brake pedal several times.
2. Fill master cylinder. Install clear vinyl bleeder hose onto first bleeder valve to be serviced. Place other end of hose in clean transparent container.
3. Partially fill container with clean brake fluid so end of hose is submerged in fluid. Open bleeder valve 1-2 turns. (See Brake Line Bleeding Sequence below) Slowly depress brake pedal through its full travel.
4. Close bleeder valve and release pedal. Pump pedal several times to push air toward wheel cylinders. Repeat procedure until flow of brake fluid is clear and shows no signs of air bubbles. Proceed to next bleeder valve.

Brake Line Bleeding Sequence

1. Right Rear
2. Left Rear
3. Right Front
4. Left Front

NOTE: Check fluid level in master cylinder frequently during the bleeding sequence.